5.0★★★★★34 Google reviews Owner-installed · 30+ years · Serving Scottsdale & the Valley (480) 241-8468

Film selection

Choosing the Right Window Film for Arizona Sun

Ceramic, spectrally selective, dual-reflective, safety or decorative: what each film does, how to read the numbers, and which one fits your glass.

Living room with a full run of panoramic windows over the desert

There’s no single “best” film. There’s the best film for your glass, your problem and the look you want. Here’s how the main types compare, and how to read the numbers on a spec sheet.

Our films. We install MaxPro Window Films, made in America and stocked by a local distributor. Every film below is the same price, $10 per square foot installed, so you choose on performance and look alone. Cost guide →

The main film families

Spectrally selective & nano-ceramic

Designed to block infrared heat while letting most visible light through, so rooms stay bright and the glass looks close to clear. A film is usually called spectrally selective when its light-to-solar-gain ratio is 1.25 or higher. The go-to choice for Arizona homes that want heat control without a tinted look, and often the most compatible option on dual-pane and Low-E glass.

Dual-reflective

More reflective on the outside for daytime privacy and strong heat rejection, less reflective on the inside to reduce the mirror effect at night. Night-time privacy is reduced, not eliminated. At night, the brighter side is the one people can see into.

Reflective / metallized

Maximum heat rejection and a mirrored exterior. Common on commercial buildings. Can be more absorptive, so glass compatibility needs closer attention, and some metallized films can affect cell signal.

Clear UV film

Virtually invisible and blocks about 99% of UV. It’s the simplest answer when fading is the only problem.

Safety & security film

Thicker, clear polyester that helps hold broken glass together after an impact or break-in attempt. Tested to safety-glazing standards such as ANSI Z97.1. It slows entry and reduces flying glass, but it is not bulletproof. Security film →

Frosted & decorative

Full-time privacy while keeping daylight: bathrooms, entries, sidelights, office partitions, and branded or patterned glass. Privacy & decorative film →

Reading a spec sheet

NumberWhat it meansWhat to look for
VLT (visible light transmitted)How much daylight gets throughHigher = brighter, more natural look
TSER (total solar energy rejected)Share of all solar energy (heat) the film + glass rejectsThe best single heat number to compare films
IR rejectionShare of infrared rejected, which is only part of the sun’s heatOften the biggest number on a brochure; don’t compare it to another film’s TSER
SHGC (solar heat gain coefficient)Share of solar heat that gets in (lower is better)Used by utilities and window makers
Glare reductionHow much visible glare is cutMatters for screens and west views
UV rejectionShare of UV blockedQuality films block about 99%
Numbers are always for a specific film on a specific glass. The same film performs differently on dual-pane or Low-E glass.

About “up to 95% heat rejection.” Claims like that usually refer to infrared rejection on a premium ceramic film. It’s a real number, but it isn’t total heat. We’ll give you both figures, IR and total solar energy rejected, for the specific film on your glass.

Matching film to the problem

If your main problem is…Start with…
Heat, but you want it to look clearSpectrally selective / nano-ceramic
Heat + privacy from the streetDual-reflective
Glare on screensLight-to-medium ceramic or dual-reflective
Fading onlyClear UV film
Bathroom or entry privacyFrosted or decorative
Break-ins or large exposed panesSafety / security film

Whatever you choose, it has to be approved for your glass. How we check dual-pane and Low-E compatibility →

See what the right film does for your glass.

Free on-site estimate. We identify your glass, measure the heat, and show you film samples on your own windows.

Call Text Free estimate